How To Change Battery On Nite Ize Frisbee?

As an Amazon Associate, I Earn From Qualifying Purchases.

Last Updated on September 23, 2022 by Ellis Gibson (B.Sc. in Mechanical Engineering)

You’re at your friend’s house for a cookout and there’s only one thing on your mind: frisbee. You love playing frisbee, but when you go to grab the frisbee, you realize the battery is dead. You’re not sure how to change the battery on the frisbee, but you’re determined to figure it out. With a little bit of research, you find this article and read on.

So, how to change battery on nite ize frisbee?

To change the battery on a Nite Ize Frisbee, you will need to remove the screws that hold the battery cover in place. Once the cover is removed, you will be able to access the batteries. To remove the batteries, you will need to unscrew the two screws that hold them in place. Once the screws are removed, you will be able to take the batteries out and replace them with new ones.

Let’s dig into it and find out what’s going on.

Step By Step Process On: How To Change Battery On Nite Ize Frisbee?

Here I will explain you step by step process of how to change battery on nite ize frisbee? let’s see how to change battery on nite ize frisbee.


  1. Flathead screwdriver
  2. CR2016 three volt watch batteries (2)
  3. Patience


First, you will need a flathead screwdriver, a pair of CR2016 three volt watch batteries, and a bit of patience.


Using the screwdriver, gently pry the cap off of the battery compartment. Be careful not to damage the compartment as you do this.


Once the cap is off, you will have access to the light module. Gently remove the old batteries from the module and replace them with the new ones. Make sure the new batteries are inserted positive side up.


Once the new batteries are in place, reassemble the light module and screw the cap back on.


Test your flashlight to make sure it is working properly. Once it is, you are all done!

If you wanted to watch a youtube video that shows you how to change battery on nite ize frisbee? I have included a video below:

How To Change Batteries In Light Up Frisbee?

It’s easy to change the batteries in a light up frisbee- all you need is a screwdriver and a new set of batteries. First, unscrew the four screws that hold the battery cover in place. Then, remove the old batteries and insert the new ones, making sure that the positive and negative ends are facing the correct way. Finally, screw the battery cover back on and you’re good to go!

How Do I Change A Disc Battery?

If your car has a disc brake system, the brakes are most likely powered by a hydraulic system. This means that when you press the brake pedal, fluid is forced through a series of valves and hoses to the brake calipers. The calipers then press the brake pads against the brake rotors, which slows the wheels.

The disc brake system also has a disc brake pads wear sensor. When the pads start to wear down, the sensor sends a signal to the brake light on the dash, warning you that it’s time to change the pads.

Changing the disc brake pads is a pretty easy job that most people can do themselves. You’ll need a few basic tools, including a socket wrench, and it’s a good idea to have a friend help you so they can hold the wheel while you work.

1. Park the car on a level surface and set the parking brake.

2. Remove the wheel.

3. Use the socket wrench to remove the two bolts that hold the caliper in place.

4. Take the old pads out of the caliper and put the new ones in.

5. Reattach the caliper and bolts.

6. Put the wheel back on and lower the car.

7. Test the brakes to make sure they’re working properly.

Can I Change The Battery On My Nite Ize Frisbee Myself?

We get this question a lot, and the answer is… maybe! If you feel comfortable taking apart your Frisbee and replacing the battery, then go for it! But if you’re not sure, or don’t feel comfortable, we recommend taking it to a local electronics store or qualified technician.

Should I Change The Battery On My Nite Ize Frisbee Myself?

If you’re the Do-It-Yourself type, you may be wondering if you can change the battery on your Nite Ize Frisbee yourself. The answer is: yes, you can! Just follow these simple steps:

1. Remove the back cover of the Frisbee. You’ll see two small screws holding it in place. Use a Phillips head screwdriver to remove them.

2. Carefully pull the back cover off. You’ll see the battery compartment and the two batteries inside.

3. Use a small screwdriver to remove the positive and negative terminals from the batteries.

4. Insert the new batteries, making sure to connect the positive and negative terminals correctly.

5. Replace the back cover and screw it in place.

That’s it! You’ve successfully changed the batteries in your Nite Ize Frisbee.

How Do You Replace The Batteries In An Aerobie Skylighter?

To replace the batteries in an Aerobie Skylighter, unscrew the cap at the bottom of the unit and insert three AAA batteries.

What Is The Cr2016 Battery Life?

The cr2016 battery life is a disposable lithium coin battery with a diameter of 20 mm and a height of 1.6 mm. It is used in a variety of applications, including watches, calculators, and keyless remote entry systems. The battery provides a voltage of 3 V and a capacity of 85 mAh.

How Does One Play Kan Jam With A Light Up Frisbee?

To play Kan Jam with a light up Frisbee, one would need to purchase a light up Frisbee and a Kan Jam set. The Kan Jam set would need to be assembled according to the included instructions. Once the Kan Jam set is assembled, one would need to choose teams of two players each. The object of the game is for each team to take turns throwing or deflecting the Frisbee at the Kan Jam goal in order to score points. The first team to score 21 points wins the game.

Can You Play Catch With A Flashflight Frisbee In The Dark?

Yes, you can play catch with a flashflight frisbee in the dark. The flashflight frisbee has a built in LED light that makes it visible in the dark.

How Do I Dispose Of The Old Battery From My Nite Ize Frisbee?

First, remove the old battery from your Nite Ize Frisbee. Next, find a recycling center that accepts batteries. Finally, take the old battery to the recycling center.

What Is The Warranty On My Nite Ize Frisbee?

The warranty on your Nite Ize Frisbee is as follows:

For one year from the date of purchase, we warrant this product against defects in materials and workmanship.

If a defect arises during that year, we will, at our option, repair or replace the product, or refund the purchase price.

Will Changing The Battery On My Nite Ize Frisbee Void The Warranty?

No, changing the battery on your Nite Ize Frisbee will not void the warranty.

I Can’T Figure Out How To Change The Battery On My Nite Ize Frisbee. Help! 15. I’M Having Trouble Changing The Battery On My Nite Ize Frisbee. What Should I Do?

First, try looking in the Frisbee’s manual for instructions on how to change the battery. If you can’t find the manual or if the instructions are unclear, you can also try searching online for a tutorial on how to change the battery on your specific model of Frisbee. If you’re still having trouble, you can contact Nite Ize customer support for help.

Final Word

That’s all there is to it! Changing the battery on your Nite Ize Frisbee is a quick and easy process that anyone can do. With just a few simple steps, you’ll be back to playing with your Frisbee in no time. Thanks for reading and we hope you have a great time playing with your Frisbee!


How Much Does The Flashflight Disc Golf Disc Weigh?

According to the manufacturer, the Flashflight disc golf disc weighs 175 grams.

Do Galaxy Discs Glow In The Dark?

Unfortunately, we do not have enough information to answer this question definitively. However, it is possible that galaxy discs may glow in the dark.

How Does The Nite Ize Flashflight Led Light Up Flying Disc Work?

The Nite Ize Flashflight LED light up flying disc is a battery-powered flying disc that has an LED light in the center. The LED light is activated by a button on the side of the disc. When the button is pressed, the LED light will turn on and the disc will start to glow. The light will stay on for a few seconds and then turn off.

What Is The Size Of An Lr44 Battery?

Additionally, the lr44 battery is a type of button cell battery.

Related Post: